how to replace the wax mold?

When the compressor oil consumption greatly increased, check the oil filter and pipeline, oil return pipe and so on are blocked and cleaned, if the wax mold is still large, it may be Tianjin oil and gas separator oil and gas separator Has been deteriorated, the need for timely replacement;


when the wax mold and gas separation filter at both ends of the pressure difference of 0.15MPa should be replaced; when the pressure is 0, indicating that the filter is faulty or air flow has been shortcircuit, this time also apply the replacement of submersible protector Filter element.


Replace the steps as follows:

(1), external models

A, compressor shutdown, air pressure outlet is closed, the drain valve opens, confirm the system without pressure.

B, the wax mold and gas separator removed after the replacement of new products.

(2), built-in models

A, compressor shutdown, air pressure outlet is closed, the drain valve opens, confirm the system without pressure.

B, the oil and gas barrels above the pipe open, while the pressure to maintain the valve to the valve to remove the outlet.

C, remove the return pipe.


For more information aboutProtector accessories|Separator accessories|Pump parts|impeller|diffuser|wax mold|Motor parts|Cable protector, etc., please visit Tianjin JHS Machinery Equipment Co., Ltd. official website! (http://www.jhsesp.com/en/)


Prev
Full name
Telephone
Content
Verification code
 Change Image
*
Submit
天津景昊升机械设备有限公司
Tianjin JingHaoSheng machinery equipment co., LTD
Contact us
Contact: manager Chen
Tel:
Company address: YangBa Industrial Park,Ninghe District,Tianjin